Follow these steps to connect your Dahua CCTV system and view it on your PC: 1. Connect the Dahua recorder, camera and any other components of your system via data cables according to their specifications. 2. Connect an ethernet cable from your router/switch/PC into each device’s RJ-45 port.

Make sure your camera network is NOT in the same range as the client's existing network. Always verify the customers IP range BEFORE setting up the recorder; failure to do so will cause multiple issues, primarily the failure to detect the cameras. 5. After entering your IP addresses for Network 1 and Network 2, continue to follow the setup
CCTV dahua DVR repair troubleshooting no display and power problem. Jj Mo To 50 subscribers Subscribe Subscribed 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 Share 8.5K views 1
Ensure that your NVR is connected to your router via wifi. 2. Access the NVR’s web interface via a web browser. 3. Navigate to the Network menu and select the Wireless tab. 4. Select the SSID of your wifi network from the drop-down menu. 5. Enter your wifi password in the Password field. http://cpplusdvr.comDVR Display Out of Range! DVR Not Display in Monitor! DVR Out of Range! 2019!If your dvr shown an error out of range then you can watch t Fix the configuration. The Hikvision DVR allows you to select the channels you want to display on the screen and hiding the ones you don't want to. It's just a question of configuration. To change the configuration open the Configuration menu. Click on the " Live View" button to open the next screen. Check which channels are being displayed. Answer: If motion detection is not working there are a few settings that need to be checked: Confirm the detection grid is created. Sensitivity is more than 0. The arming schedule is created for the times you need. Trigger channel has the appropriate channel selected. Recording schedule is created and enabled. Did you find it helpful?

Hey guys, not new here but first post! I just swapped an outdated Exacquvision/IVT system for a 32 channel Dahua NVR. All is well other than none of the Channel names or dates are showing. See Photo I have the expected settings.. But I cannot save these settings, nor alter their settings, after the boxes are checked.

1. Install ConfigTool, Run and Open. 2. Upon opening the ConfigTool application, here you can see Dahua Devices on the same LAN are located. Refresh if Dahua devices are not located. You can also manually locate the device by typing in the IP address of the device in the search. 3. To view the device live click on the IE (Internet Explorer) icon.
.
  • lm90dihp9c.pages.dev/581
  • lm90dihp9c.pages.dev/904
  • lm90dihp9c.pages.dev/867
  • lm90dihp9c.pages.dev/335
  • lm90dihp9c.pages.dev/892
  • lm90dihp9c.pages.dev/564
  • lm90dihp9c.pages.dev/622
  • lm90dihp9c.pages.dev/210
  • lm90dihp9c.pages.dev/207
  • lm90dihp9c.pages.dev/56
  • lm90dihp9c.pages.dev/186
  • lm90dihp9c.pages.dev/331
  • lm90dihp9c.pages.dev/767
  • lm90dihp9c.pages.dev/991
  • lm90dihp9c.pages.dev/143

    • dahua dvr not displaying